Type: | Surfing Simulator |
---|---|
Material: | 304 Stainless Steel |
Max Capacity: | >500kg |
Customization: |
---|
Shipping Cost:
Estimated freight per unit. |
about shipping cost and estimated delivery time. |
---|
Payment Method: | |
---|---|
Initial Payment Full Payment |
Currency: | US$ |
---|
Return&refunds: | You can apply for a refund up to 30 days after receipt of the products. |
---|
Suppliers with verified business licenses
Total equipment power 230-500kw
Three modes can be switched
Mode 1, normal mode, power 260kw-280kw, wave height about 0.7-0.9 meter
Mode 2, professional mode, power 350kw, wave height about 0.9-1.2 meters
Mode 3, ultimate mode, power 450kw, wave height 1.3- 1.6 meters
Product Name | Customized Surf Pool Machine Sets |
Model | FL-200 |
Size | Customized Size |
Material | 304 Stainless Steel+PVC |
Equipment | Space bowl slide, swimming pool slide group, children pool, water splash pad, wave pool |
Approximate price | $485k-$700k |
Capacity | 1 Rider/Time |
Service Life | Over than 30 Years |
Installation | Seller provide installation construction file and installation manual. Engineer on-site service(extra cost) |
1. Bubble-wrapped (EPE foam) and fumigated timber frame for FRP parts.
2. Ensure the safety of transportation.
3. Nude packing for steel parts.
4. Extra spare parts for accidental loss.
Installation requirements instructions
1. The recommended site size for the equipment is 30*25 meters (optimal size), the height is more than 2.8 meters, and the equipment length is 25-30 meters
meters, the equipment width is 15-25 meters, the water pump power is 220 kW-440 kW, the heat source power is 60 kW, and the water treatment power is 6
kilowatt.
2. Technical requirements for civil construction ground:
1. The pool body is a reinforced concrete structure with a minimum concrete strength grade of C30 and an impermeability grade of P6.
2. The dimensional deviation (mm) of the cast-in-place structure after formwork removal should meet the following requirements:
Plane dimensions: ±20; vertical height: ≤10;
Elevation: ±30; Surface flatness: 8;
The center position of the embedded parts: is 10, and must not be dented; the center position of the reserved hole: is 15.
3. The cast-in-place structure must not have looseness, cracks, loose connections, uneven edges, uneven warping, flashing, or protruding ribs,
Surface quality defects such as surface pitting, peeling, and sanding that affect the use function.
4. During installation, chemical anchors 12cm deep will be drilled into the pool, so the distance between the structural reinforcement layer and the finished surface should be no less than
12cm, with sufficient strength, no looseness, peeling, or delamination, and surface smoothness within 5mm.
5. In order to prevent cracks and leakage caused by concrete shrinkage and deformation, it is necessary to install waterproofing with certain deformation adaptability.
The material is fully waterproof (need to prevent damage caused by chemical anchor bolts).
6. To facilitate soft packaging, all wall corners must not be chamfered or beveled.
8. The surface treatment of the exterior of the pool above the ground shall be considered by the landscape professional.
9. Pedestrian ramps should be treated with anti-slip treatment and soft hydrophobic floor mats should be laid.
10. The location of water supply and drainage pipelines and openings shall be determined by the water supply and drainage professional.
Suppliers with verified business licenses